How to solve the bending and deformation of charcoal produced by charcoal machine

Charcoal machine equipment has high output, low energy consumption, easy operation, stable quality and high cost performance. The environmental protection of the charcoal produced by the charcoal machine not only responds to the environmental protection concept advocated by the country, but also has almost no impact on environmental pollution. It also reuses discarded sawdust and waste materials, turning waste into treasure; Secondly, the charcoal content of the charcoal machine is very high, and the average value can reach more than 80%; Thirdly, the charcoal produced by the charcoal machine is clean and hygienic, smokeless and pollution-free, and the residual ash produced during the combustion process will fall by itself, and will not produce pollution or harmful substances in the air; Finally, it should be emphasized that the charcoal produced by the charcoal machine is formed by the equipment at one time, with uniform size and length, reasonable structure, and easy use. However, during production, the finished charcoal rods will be bent and deformed. What should we do at this time? The main factors affecting the shape of charcoal machine rods are unreasonable design of accessories of charcoal machine rod equipment and the moisture content of raw materials for making rods does not meet the standard.

1. The accessories design of the charcoal machine rod making equipment is unreasonable: the cross-sectional gap between the rod making machine propeller and the forming cylinder will affect the forming resistance of the raw materials, resulting in uneven pressure flow rate when the raw materials pass through the propeller, resulting in the extrusion and deformation of the formed firewood sticks. Therefore, before making the sticks, it is necessary to check whether the movement combination of each rod making accessory is normal.

2. The moisture content of the raw materials for making sticks. The moisture content in the raw materials has a certain influence on the charcoal machine rods. If the moisture content of the raw materials is too high, the plastic forming standard will not meet the standard hardness during the rod making process, so the extruded firewood sticks will naturally be bent. Therefore, the moisture content of the raw materials must be removed before making sticks. If the moisture content is too high, a dryer can be equipped.