How to operate the newly purchased charcoal machine equipment to ensure its service life

For the purchase of Charcoal machine equipment, some impatient customers directly process charcoal after the equipment arrives. On the one hand, they look at the function of the charcoal machine equipment, on the other hand, they observe the degree of discharge and quickly enter the production state. We can understand this mood, but when new customers are not familiar with the use of charcoal machine equipment, they blindly start the machine and put it into production blindly. They encounter problems in production and then solve them. This is easy to cause unnecessary losses to customers. This is the phenomenon that Kaibang is most reluctant to see. For this reason, we have summarized some methods for the correct use of new machine debugging to help new customers extend the life of the charcoal machine.

1. Ensure that all the connecting screws of the charcoal forming machine are connected and tightened, especially the three tops in the heating cylinder, which must be tight.

2. After ensuring the stable installation of the equipment, all lubrication parts of the equipment such as the briquette machine, wood chip crusher, and airflow dryer need to be checked and gear oil added to ensure smooth operation of the equipment.

3. Connect the power supply of the main control box and install the standard safety wiring. Do not start the machine rashly at this time. You can start it for three to five minutes to see if there are any abnormal phenomena such as card or collision. If not, it can be put into production normally. Once the above situation occurs, you need to stop the machine immediately for inspection to completely eliminate the fault.

4. The new machine needs to ensure that the equipment heats up slowly. After the temperature rises, you can start the machine and feed the material into it.

5. In the process of feeding, remember not to be too fast. When the charcoal molding machine equipment works normally for 30 minutes, it can be turned off. At this time, it means that the test run has been successful and normal production can be carried out.