The correct steps for normal startup and debugging of charcoal machine equipment

People who buy Charcoal machine equipment are always worried about whether the equipment can operate normally. Some impatient customers directly use raw materials to process charcoal after the machine arrives at the site. On the one hand, they look at the functionality of the charcoal machine equipment, and on the other hand, they observe the degree of discharge and quickly enter the production state. We can understand this mood, but when new customers are not familiar with the use of charcoal machine equipment, they blindly start the machine and put it into production blindly. When they encounter problems in production, they will understand and solve them. In this case, avoidable phenomena often occur, which also causes unnecessary losses to customers. This is a phenomenon that Kaibang does not want to see, so we have summarized some methods for the correct use of new machine debugging to help new customers extend the use of charcoal machines.

1. To ensure that all the connecting screws of the charcoal forming machine are connected and tightened, especially the three tops in the heating cylinder, they must be tight.

2. After ensuring that the equipment is installed stably, all lubricating parts of equipment such as briquette machines, wood chip crushers, and airflow dryers need to be checked and gear oil added to ensure smooth operation of the equipment.

3. Connect the power supply of the main control box and install the standard safety wiring. Do not start the machine rashly at this time. You can start it for three to five minutes to see if there are any abnormal phenomena such as card or collision. If not, it can be put into production normally. Once the above situation occurs, you need to stop the machine immediately for inspection to completely eliminate the fault.

4. The new machine needs to ensure that the equipment heats up slowly. After the temperature rises, you can start the machine and feed the material into it.

5. In the process of feeding, remember not to be too fast. When the charcoal forming machine equipment works normally for 30 minutes, it can be turned off. At this time, it means that the test run has been successful and normal production can be carried out.

These seemingly simple problems are often ignored by many people. It can help new customers master the use of charcoal machines as soon as possible and extend the service life of charcoal machine equipment. It seems to be a simple truth, but it requires long-term persistence. Kaibang charcoal machine manufacturers wish new charcoal machine customers safe production and prosperous business.