Summary of the sudden failure of the equipment by the Kaibang charcoal machine manufacturer

It is inevitable that various failures will occur during the operation of the Charcoal machine. People who are not familiar with these problems will inevitably be confused and at a loss. The formation of charcoal is determined by a series of problems such as the selection of raw materials, the control of carbonization temperature, the temperature and density of the rod making machine, the control of the moisture content of raw materials, and the size of the raw material crusher. In view of the occurrence of failures, the Kaibang charcoal machine factory has sorted out the failures that are easy to occur in the charcoal making process of the charcoal machine, and the users of the Kaibang charcoal machine can refer to it for comparison.

1. Q: Why is the effect of the same raw materials on different rod making machines so different?

A: The reason for this is that the clearance between the screw and the sleeve is not suitable.

2. Q: What is the reason for smoke coming out from all sides of the rod and the rods being relatively rough or not being made when making rods?

A: It is because the raw materials used in the rod making are too dry, the clearance between the screw and the sleeve is too large, or the temperature is too high.

3. Q: Why do explosions, abnormal rods or slow speeds, and eye plugging often occur during rod making?

A: The front edge of the spiral is seriously worn, the root of the front edge of the spiral is seriously worn, or the sleeve is seriously worn.

4. Q: Why is the stick made by the charcoal machine dense, but the stick breaks when it is bent, and the broken side is shiny?

A: It is because the initial front edge of the spiral is too high.

5. Q: Why does carbonization occur when the temperature is slightly higher during the stick making process, and no stick is produced as long as the temperature is slightly lower?

A: It shows that the sleeve of the charcoal machine is seriously worn.

6. Q: Why is the stick making not smooth and blasting?

A: The temperature is too low, the raw material is too wet, or the matching gap is not appropriate.

7. Q: Why are the made sticks bent?

A: The raw material for making sticks is not dried and has high humidity.

8. Q: What is the reason for the poor density and fast speed of making sticks?

A: The screw is adjusted too long or the temperature is too high.

9. Q: Why is the stick speed slower after changing the screw? (The raw material of the screw is the same)

A: The first spiral of the screw is too high.

10. Q: Why does the backflow phenomenon occur?

A: The machine runs for a long time when the raw material is too wet or the rod does not move due to other reasons.

11. Q: What is the situation of the screw running idle?

A: The screw is too short or worn.

12. Q: Why does the rod not come out and the screw is screwed together?

A: The temperature is too low, the screw is too short or worn.