What are the common charcoal machine equipment production failures?

In recent years, the more popular charcoal making equipment is the Charcoal machine. Among them, Kaibang Machinery summarizes the common failures of this equipment here for reference by newcomers who have just entered the charcoal machine industry.

The common failure of charcoal machine equipment production is on the Sawdust Briquette Machine propeller. Of course, you don’t have to worry about the failure. Kaibang charcoal machine manufacturers provide you with methods to solve your problems. It is more common that the Sawdust Briquette Machine is not formed, which may be due to the following reasons: improper temperature control, excessive moisture in raw materials, wear of the Sawdust Briquette Machine propeller, misalignment of the shaft tip, blockage of the exhaust hole, excessive or too small spiral of the Sawdust Briquette Machine propeller, and serious wear of the sleeve. In this case, you should check the above reasons one by one, find out the reasons and make corresponding adjustments. Secondly, the surface cracks of the machine-made charcoal are too high in raw material moisture, which is easy to cause transverse cracks on the rod body, and too little moisture will cause longitudinal cracks. In addition, too high heating temperature will cause excessive softening of the raw materials, resulting in insufficient feeding. This will also cause cracks. Sometimes the feeding barrel of the charcoal machine equipment will not supply enough material. This solution can be to increase the spiral diameter appropriately, or grind the spiral wall, and increase the gear spacing between the spirals. Another type is that the charcoal machine equipment has a bright surface, that is, there is a bright light on the cross section of the rod. Although the density is good, the hardness is not good. This is because the initial part of the first spiral is too steep, and it should be polished to be smoother. Another common problem is that the charcoal machine equipment is blocked. This may be because large and hard impurities are mixed into the raw materials. Or the heating temperature is too low. The former requires the charcoal machine equipment to be stopped and disassembled to remove impurities. The latter requires continuing to heat and soften the raw materials. The heating temperature of the Sawdust Briquette Machine is too high or too low because the forming sleeve of the charcoal machine equipment is seriously worn, the angle of the screw propeller is inconsistent, and the moisture content of the raw materials is too high. When the Sawdust Briquette Machine is working normally, the formed rods are evenly extruded from the sleeve. The machine-made rods should be dark brown, with uniform hardness, smooth surface, no cracks, and the surface of the center hole is also smooth, and the exhaust is smooth. The center of the machined rod has a low density or contains scattered sawdust. This is because the diameter of the screw propeller shaft tip is worn, and it needs to be welded and thickened. The misalignment of the shaft tip can also cause the above problems, and it needs to be corrected at high temperature. If the rod is bent, it may be because the raw material has too much moisture.